EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SR3Q Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR3Q. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1773777464	207 Count	499 Count	166 Count
1773776863	202 Count	492 Count	162 Count
1773776263	200 Count	487 Count	161 Count
1773775662	196 Count	481 Count	158 Count
1773775062	190 Count	471 Count	153 Count
1773774461	187 Count	463 Count	151 Count
1773773861	182 Count	452 Count	147 Count
1773773260	178 Count	445 Count	144 Count
1773772659	175 Count	440 Count	142 Count
1773772058	170 Count	433 Count	138 Count
1773771457	163 Count	421 Count	132 Count
1773770857	160 Count	407 Count	130 Count
1773770256	155 Count	390 Count	126 Count
1773769656	149 Count	374 Count	121 Count
1773769055	146 Count	363 Count	119 Count
1773768455	141 Count	351 Count	115 Count
1773767854	134 Count	335 Count	109 Count
1773767254	131 Count	319 Count	107 Count
1773766653	126 Count	305 Count	103 Count
1773766053	120 Count	291 Count	98 Count
1773765452	117 Count	273 Count	96 Count
1773764873	112 Count	255 Count	92 Count
1773764272	105 Count	241 Count	86 Count
1773763672	101 Count	233 Count	83 Count
1773763071	95 Count	222 Count	78 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)