EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP8SOB-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8SOB-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1793181573	673 Count	780 Count	411 Count
1793178871	661 Count	769 Count	402 Count
1793177970	659 Count	767 Count	401 Count
1793177069	657 Count	766 Count	400 Count
1793176168	655 Count	764 Count	399 Count
1793175269	653 Count	762 Count	398 Count
1793174367	651 Count	760 Count	397 Count
1793173467	649 Count	757 Count	396 Count
1793172566	646 Count	754 Count	394 Count
1793171665	644 Count	752 Count	393 Count
1793170764	643 Count	752 Count	393 Count
1793169864	641 Count	751 Count	392 Count
1793168963	639 Count	749 Count	391 Count
1793168063	637 Count	747 Count	390 Count
1793167162	635 Count	746 Count	389 Count
1793166261	633 Count	744 Count	388 Count
1793165361	631 Count	742 Count	387 Count
1793164461	629 Count	738 Count	386 Count
1793163559	627 Count	737 Count	385 Count
1793162659	625 Count	734 Count	384 Count
1793161758	623 Count	732 Count	383 Count
1793160858	621 Count	730 Count	382 Count
1793159957	619 Count	729 Count	381 Count
1793159056	612 Count	722 Count	375 Count
1793158156	610 Count	720 Count	374 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)