EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ9IKM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9IKM-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1775645352	210 Count	326 Count	105 Count
1775644451	208 Count	323 Count	104 Count
1775643551	205 Count	320 Count	102 Count
1775642650	202 Count	316 Count	100 Count
1775641749	200 Count	313 Count	99 Count
1775640849	197 Count	309 Count	97 Count
1775639948	196 Count	307 Count	97 Count
1775639047	194 Count	306 Count	96 Count
1775638147	192 Count	305 Count	95 Count
1775637246	189 Count	303 Count	93 Count
1775636345	187 Count	302 Count	92 Count
1775635445	185 Count	300 Count	91 Count
1775634544	183 Count	299 Count	90 Count
1775633644	181 Count	298 Count	89 Count
1775632743	178 Count	295 Count	87 Count
1775631842	176 Count	294 Count	86 Count
1775630942	173 Count	291 Count	84 Count
1775630041	170 Count	289 Count	82 Count
1775629140	167 Count	287 Count	80 Count
1775628253	165 Count	285 Count	79 Count
1775627352	163 Count	282 Count	78 Count
1775626452	161 Count	281 Count	77 Count
1775625551	159 Count	280 Count	76 Count
1775624650	157 Count	279 Count	75 Count
1775623750	155 Count	278 Count	74 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)