EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ9IKM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9IKM-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1794544102	62 Count	131 Count	36 Count
1794543201	59 Count	126 Count	34 Count
1794542301	57 Count	122 Count	33 Count
1794541400	54 Count	118 Count	31 Count
1794540500	52 Count	113 Count	30 Count
1794539614	49 Count	106 Count	28 Count
1794538713	47 Count	101 Count	27 Count
1794537812	45 Count	98 Count	26 Count
1794536912	42 Count	93 Count	24 Count
1794536011	39 Count	89 Count	22 Count
1794535110	36 Count	83 Count	20 Count
1794534210	34 Count	79 Count	19 Count
1794533309	32 Count	70 Count	18 Count
1794532409	30 Count	66 Count	17 Count
1794531508	28 Count	62 Count	16 Count
1794530607	26 Count	59 Count	15 Count
1794529707	24 Count	53 Count	14 Count
1794528806	22 Count	50 Count	13 Count
1794527905	20 Count	46 Count	12 Count
1794527005	17 Count	42 Count	10 Count
1794526104	15 Count	37 Count	9 Count
1794525203	12 Count	31 Count	7 Count
1794524303	10 Count	26 Count	6 Count
1794523402	7 Count	22 Count	4 Count
1794522503	5 Count	14 Count	3 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)