EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ9PD-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9PD-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1771479218	52 Count	858 Count	40 Count
1771478318	48 Count	791 Count	37 Count
1771477417	44 Count	724 Count	34 Count
1771476516	39 Count	654 Count	30 Count
1771475615	36 Count	578 Count	28 Count
1771474715	31 Count	527 Count	24 Count
1771473814	28 Count	485 Count	22 Count
1771472913	23 Count	428 Count	18 Count
1771472013	19 Count	365 Count	15 Count
1771471112	14 Count	295 Count	11 Count
1771470211	11 Count	204 Count	9 Count
1771469311	7 Count	121 Count	6 Count
1771468410	4 Count	58 Count	4 Count
1771467509	86 Count	1017 Count	61 Count
1771466609	82 Count	955 Count	58 Count
1771465708	77 Count	901 Count	54 Count
1771464807	74 Count	845 Count	52 Count
1771463907	69 Count	781 Count	48 Count
1771463022	61 Count	733 Count	45 Count
1771462121	57 Count	679 Count	42 Count
1771461220	53 Count	624 Count	39 Count
1771460320	49 Count	598 Count	36 Count
1771459419	45 Count	548 Count	33 Count
1771458518	40 Count	486 Count	29 Count
1771457617	36 Count	439 Count	26 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)