EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SR2INO-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2INO-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1771687904	295 Count	186 Count	24 Count
1771686103	282 Count	177 Count	23 Count
1771684303	272 Count	168 Count	22 Count
1771682502	261 Count	158 Count	21 Count
1771680707	238 Count	149 Count	20 Count
1771678907	217 Count	139 Count	19 Count
1771677106	203 Count	129 Count	18 Count
1771675305	182 Count	119 Count	17 Count
1771673505	168 Count	109 Count	16 Count
1771671704	154 Count	98 Count	15 Count
1771669904	141 Count	89 Count	14 Count
1771668103	118 Count	78 Count	13 Count
1771666303	102 Count	66 Count	11 Count
1771664502	87 Count	54 Count	10 Count
1771662701	54 Count	27 Count	3 Count
1771660901	33 Count	18 Count	2 Count
1771659107	14 Count	8 Count	1 Count
1771657307	1000 Count	418 Count	40 Count
1771655506	983 Count	407 Count	39 Count
1771653705	966 Count	398 Count	38 Count
1771651905	948 Count	388 Count	37 Count
1771650104	927 Count	379 Count	36 Count
1771648304	903 Count	370 Count	35 Count
1771646503	889 Count	361 Count	34 Count
1771644703	874 Count	351 Count	33 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)