EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

M0MXL Telemetry

This is the latest recevied telemetry packets stored in our database for station/object M0MXL. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1773637115	173 Count	184 Count	137 Count
1773635311	169 Count	179 Count	134 Count
1773633507	164 Count	173 Count	130 Count
1773631703	160 Count	168 Count	127 Count
1773629899	155 Count	163 Count	123 Count
1773628095	151 Count	160 Count	120 Count
1773626291	146 Count	156 Count	116 Count
1773624487	142 Count	153 Count	113 Count
1773622683	137 Count	149 Count	109 Count
1773620880	133 Count	144 Count	106 Count
1773619076	128 Count	139 Count	102 Count
1773617272	124 Count	134 Count	99 Count
1773615516	119 Count	128 Count	95 Count
1773613712	115 Count	123 Count	92 Count
1773611908	110 Count	119 Count	88 Count
1773610104	106 Count	116 Count	85 Count
1773608300	101 Count	112 Count	81 Count
1773606496	97 Count	107 Count	78 Count
1773604692	92 Count	101 Count	74 Count
1773602888	88 Count	97 Count	71 Count
1773601084	83 Count	91 Count	67 Count
1773599280	77 Count	85 Count	62 Count
1773597476	66 Count	75 Count	52 Count
1773595676	62 Count	71 Count	49 Count
1773593916	57 Count	66 Count	45 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)