EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP6TPX-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP6TPX-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1773835646	19 Count	155 Count	14 Count
1773833879	15 Count	128 Count	11 Count
1773832076	9 Count	96 Count	6 Count
1773830273	8 Count	76 Count	6 Count
1773828470	7 Count	60 Count	6 Count
1773826667	2 Count	32 Count	2 Count
1773824864	189 Count	1023 Count	154 Count
1773823061	184 Count	992 Count	150 Count
1773821258	181 Count	966 Count	148 Count
1773819455	178 Count	945 Count	146 Count
1773817651	177 Count	921 Count	146 Count
1773815848	175 Count	898 Count	145 Count
1773814045	172 Count	868 Count	143 Count
1773812279	167 Count	840 Count	139 Count
1773810475	161 Count	813 Count	134 Count
1773808672	158 Count	790 Count	132 Count
1773806869	154 Count	764 Count	129 Count
1773805066	152 Count	739 Count	128 Count
1773803263	148 Count	707 Count	125 Count
1773801460	144 Count	680 Count	122 Count
1773799657	142 Count	658 Count	121 Count
1773797854	141 Count	634 Count	121 Count
1773796051	140 Count	607 Count	121 Count
1773794248	138 Count	585 Count	120 Count
1773792445	135 Count	563 Count	118 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)