EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

F5ZZW-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F5ZZW-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1789247116	226 Count	355 Count	162 Count
1789246510	223 Count	351 Count	160 Count
1789245904	220 Count	348 Count	158 Count
1789245298	219 Count	347 Count	158 Count
1789244692	218 Count	345 Count	158 Count
1789244085	215 Count	341 Count	156 Count
1789243479	214 Count	340 Count	156 Count
1789242873	212 Count	334 Count	155 Count
1789242267	208 Count	330 Count	152 Count
1789241661	207 Count	328 Count	152 Count
1789241055	204 Count	323 Count	150 Count
1789240448	201 Count	319 Count	148 Count
1789239842	200 Count	319 Count	148 Count
1789239236	197 Count	314 Count	146 Count
1789238630	194 Count	308 Count	144 Count
1789238023	193 Count	305 Count	144 Count
1789237417	189 Count	300 Count	141 Count
1789236811	186 Count	296 Count	139 Count
1789236204	185 Count	296 Count	139 Count
1789235598	181 Count	290 Count	136 Count
1789234992	178 Count	286 Count	134 Count
1789234386	176 Count	285 Count	133 Count
1789233780	173 Count	281 Count	131 Count
1789233173	170 Count	278 Count	129 Count
1789232567	165 Count	272 Count	125 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)