EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

F5ZZW-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F5ZZW-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1789190579	328 Count	751 Count	130 Count
1789189973	325 Count	745 Count	128 Count
1789189367	323 Count	742 Count	127 Count
1789188760	320 Count	736 Count	125 Count
1789188380	318 Count	734 Count	124 Count
1789187774	316 Count	728 Count	123 Count
1789187167	313 Count	721 Count	121 Count
1789186561	310 Count	717 Count	119 Count
1789185955	308 Count	711 Count	118 Count
1789185349	305 Count	706 Count	116 Count
1789184743	302 Count	702 Count	114 Count
1789184137	300 Count	695 Count	113 Count
1789183530	297 Count	691 Count	111 Count
1789182924	294 Count	688 Count	109 Count
1789182317	292 Count	685 Count	108 Count
1789181711	289 Count	680 Count	106 Count
1789181105	286 Count	676 Count	104 Count
1789180498	284 Count	673 Count	103 Count
1789179891	281 Count	670 Count	101 Count
1789179285	278 Count	668 Count	99 Count
1789178679	276 Count	664 Count	98 Count
1789178073	273 Count	658 Count	96 Count
1789177467	270 Count	654 Count	94 Count
1789176860	268 Count	650 Count	93 Count
1789176254	265 Count	645 Count	91 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)