EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP3NGH-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP3NGH-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1772107738	966 Count	468 Count	12 Count
1772105937	962 Count	439 Count	12 Count
1772104136	958 Count	377 Count	12 Count
1772102335	954 Count	310 Count	12 Count
1772100534	950 Count	245 Count	12 Count
1772098733	946 Count	181 Count	12 Count
1772096932	942 Count	139 Count	12 Count
1772095131	938 Count	109 Count	12 Count
1772093330	934 Count	84 Count	12 Count
1772091529	930 Count	81 Count	12 Count
1772089728	925 Count	70 Count	11 Count
1772087927	921 Count	69 Count	11 Count
1772086125	917 Count	68 Count	11 Count
1772084324	912 Count	63 Count	10 Count
1772082523	907 Count	52 Count	9 Count
1772080749	903 Count	48 Count	9 Count
1772078948	899 Count	47 Count	9 Count
1772077146	894 Count	44 Count	8 Count
1772075345	890 Count	44 Count	8 Count
1772073544	886 Count	44 Count	8 Count
1772071743	882 Count	44 Count	8 Count
1772069942	878 Count	44 Count	8 Count
1772068140	874 Count	41 Count	8 Count
1772066339	870 Count	41 Count	8 Count
1772064538	865 Count	36 Count	7 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)