EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

F1MCO-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F1MCO-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1776205741	5 Count	125 Count
1776203937	4 Count	107 Count
1776202133	3 Count	88 Count
1776198525	1 Count	47 Count
1776196721	0 Count	27 Count
1776194917	71 Count	1012 Count
1776191353	65 Count	970 Count
1776187745	63 Count	928 Count
1776185941	62 Count	907 Count
1776184138	61 Count	870 Count
1776182334	60 Count	837 Count
1776178726	58 Count	792 Count
1776176922	57 Count	766 Count
1776169750	49 Count	644 Count
1776162535	45 Count	537 Count
1776160731	44 Count	516 Count
1776148147	33 Count	368 Count
1776144539	31 Count	334 Count
1776140931	29 Count	299 Count
1776139127	28 Count	279 Count
1776135520	26 Count	248 Count
1776133716	25 Count	239 Count
1776130109	23 Count	212 Count
1776128304	22 Count	199 Count
1776126544	17 Count	192 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)