EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

HB9EZW-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object HB9EZW-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1771666778	394 Count	901 Count	136 Count
1771665875	392 Count	898 Count	135 Count
1771664972	391 Count	893 Count	135 Count
1771664069	389 Count	891 Count	134 Count
1771663166	387 Count	887 Count	133 Count
1771662263	386 Count	885 Count	133 Count
1771661360	385 Count	884 Count	133 Count
1771660457	383 Count	880 Count	132 Count
1771659627	382 Count	879 Count	132 Count
1771658724	380 Count	876 Count	131 Count
1771657821	379 Count	873 Count	131 Count
1771656918	377 Count	871 Count	130 Count
1771656015	376 Count	868 Count	130 Count
1771655111	375 Count	867 Count	130 Count
1771654208	373 Count	865 Count	129 Count
1771653305	371 Count	862 Count	128 Count
1771652402	369 Count	859 Count	127 Count
1771651499	368 Count	857 Count	127 Count
1771650596	367 Count	854 Count	127 Count
1771649693	364 Count	850 Count	125 Count
1771648790	363 Count	848 Count	125 Count
1771647887	361 Count	846 Count	124 Count
1771646984	360 Count	844 Count	124 Count
1771646081	359 Count	844 Count	124 Count
1771645178	357 Count	842 Count	123 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)