EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP8PB-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8PB-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1771666820	348 Count	662 Count	245 Count
1771665919	345 Count	657 Count	243 Count
1771665018	341 Count	650 Count	240 Count
1771664118	337 Count	642 Count	237 Count
1771663217	333 Count	635 Count	234 Count
1771662316	329 Count	627 Count	231 Count
1771661415	325 Count	619 Count	228 Count
1771660515	321 Count	612 Count	225 Count
1771659614	317 Count	603 Count	222 Count
1771656910	307 Count	586 Count	215 Count
1771656010	296 Count	562 Count	205 Count
1771655109	294 Count	560 Count	204 Count
1771654208	292 Count	558 Count	203 Count
1771653307	290 Count	556 Count	202 Count
1771652406	288 Count	554 Count	201 Count
1771651506	285 Count	550 Count	199 Count
1771650605	283 Count	548 Count	198 Count
1771649704	281 Count	544 Count	197 Count
1771648803	278 Count	539 Count	195 Count
1771647903	275 Count	533 Count	193 Count
1771647002	272 Count	525 Count	191 Count
1771646101	269 Count	517 Count	189 Count
1771645200	265 Count	509 Count	186 Count
1771644300	260 Count	501 Count	182 Count
1771643399	256 Count	494 Count	179 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)