EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

YC2SNK-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object YC2SNK-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1793184948	5 Count	102 Count
1793183144	4 Count	82 Count
1793181341	3 Count	68 Count
1793179537	2 Count	56 Count
1793177733	1 Count	38 Count
1793175929	0 Count	19 Count
1793174125	67 Count	1007 Count
1793172321	66 Count	990 Count
1793170562	65 Count	975 Count
1793168758	64 Count	960 Count
1793166954	63 Count	941 Count
1793165150	62 Count	923 Count
1793163346	61 Count	904 Count
1793161542	60 Count	888 Count
1793159738	59 Count	866 Count
1793157934	58 Count	848 Count
1793156130	57 Count	827 Count
1793154327	56 Count	810 Count
1793152523	55 Count	792 Count
1793150719	54 Count	776 Count
1793149830	53 Count	776 Count
1793148837	52 Count	776 Count
1793147608	51 Count	776 Count
1793146600	50 Count	776 Count
1793145875	49 Count	776 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)