EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP7K-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP7K-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1751461887	144 Count	123 Count
1751460086	143 Count	123 Count
1751458294	142 Count	123 Count
1751456493	141 Count	123 Count
1751454693	140 Count	123 Count
1751452892	139 Count	123 Count
1751451091	138 Count	123 Count
1751449290	137 Count	121 Count
1751447489	136 Count	121 Count
1751445689	135 Count	121 Count
1751443888	134 Count	121 Count
1751442087	133 Count	121 Count
1751440286	132 Count	121 Count
1751438485	131 Count	121 Count
1751436693	130 Count	113 Count
1751434893	129 Count	57 Count
1751433092	128 Count	25 Count
1751431291	127 Count	23 Count
1751429490	126 Count	21 Count
1751427689	125 Count	18 Count
1751425889	124 Count	16 Count
1751424088	123 Count	14 Count
1751422287	122 Count	12 Count
1751420486	121 Count	10 Count
1751418685	120 Count	10 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)