EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ3BKL-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ3BKL-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1773729691	230 Count	782 Count	68 Count
1773727890	216 Count	743 Count	66 Count
1773726089	207 Count	706 Count	64 Count
1773724288	192 Count	664 Count	57 Count
1773722487	184 Count	649 Count	55 Count
1773720686	178 Count	634 Count	53 Count
1773718910	171 Count	619 Count	51 Count
1773717109	165 Count	607 Count	49 Count
1773715308	159 Count	592 Count	47 Count
1773713507	152 Count	577 Count	44 Count
1773711706	146 Count	561 Count	42 Count
1773709905	140 Count	547 Count	40 Count
1773708104	134 Count	532 Count	38 Count
1773706303	128 Count	513 Count	36 Count
1773704502	122 Count	495 Count	34 Count
1773702701	116 Count	478 Count	32 Count
1773700900	111 Count	462 Count	31 Count
1773699099	105 Count	434 Count	29 Count
1773697298	99 Count	416 Count	27 Count
1773695496	93 Count	401 Count	25 Count
1773693695	87 Count	382 Count	23 Count
1773691894	75 Count	366 Count	20 Count
1773690093	69 Count	348 Count	18 Count
1773688294	63 Count	331 Count	16 Count
1773686491	57 Count	317 Count	14 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)