EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ3BKL-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ3BKL-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1773148302	248 Count	386 Count	186 Count
1773146501	237 Count	352 Count	179 Count
1773144699	228 Count	342 Count	174 Count
1773142898	199 Count	295 Count	149 Count
1773141097	172 Count	253 Count	126 Count
1773139296	158 Count	234 Count	116 Count
1773137496	144 Count	214 Count	108 Count
1773135695	130 Count	193 Count	98 Count
1773133894	112 Count	161 Count	84 Count
1773132093	91 Count	129 Count	67 Count
1773130291	53 Count	67 Count	34 Count
1773128491	33 Count	40 Count	22 Count
1773126690	456 Count	1049 Count	247 Count
1773124889	436 Count	985 Count	231 Count
1773123088	400 Count	897 Count	200 Count
1773121287	383 Count	861 Count	187 Count
1773119486	364 Count	829 Count	172 Count
1773117685	352 Count	811 Count	164 Count
1773115884	346 Count	803 Count	162 Count
1773114083	340 Count	795 Count	160 Count
1773112305	334 Count	787 Count	158 Count
1773110503	328 Count	780 Count	156 Count
1773108703	321 Count	772 Count	153 Count
1773106902	315 Count	764 Count	151 Count
1773105100	309 Count	755 Count	149 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)