EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SR2INO-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2INO-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1789231512	31 Count	385 Count
1789229713	21 Count	309 Count
1789227911	16 Count	212 Count
1789226110	11 Count	154 Count
1789224310	6 Count	96 Count
1789222508	96 Count	1142 Count
1789220708	91 Count	979 Count
1789218907	89 Count	864 Count
1789217106	87 Count	835 Count
1789215306	85 Count	785 Count
1789213512	79 Count	763 Count
1789211712	63 Count	715 Count
1789209911	61 Count	687 Count
1789208110	59 Count	654 Count
1789206309	57 Count	625 Count
1789204510	51 Count	579 Count
1789202708	45 Count	520 Count
1789200907	42 Count	480 Count
1789199106	32 Count	431 Count
1789197307	26 Count	389 Count
1789195506	20 Count	326 Count
1789191911	5 Count	184 Count
1789190110	3 Count	123 Count
1789188310	1 Count	68 Count
1789186509	34 Count	1047 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)