EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SR2INO-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2INO-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1777873352	483 Count	250 Count	26 Count
1777871551	458 Count	236 Count	25 Count
1777869751	435 Count	227 Count	24 Count
1777867950	413 Count	218 Count	23 Count
1777866149	394 Count	210 Count	22 Count
1777864348	375 Count	200 Count	21 Count
1777862547	358 Count	191 Count	20 Count
1777860746	343 Count	183 Count	19 Count
1777858946	328 Count	175 Count	18 Count
1777857153	310 Count	168 Count	17 Count
1777855352	294 Count	161 Count	16 Count
1777853552	279 Count	152 Count	15 Count
1777851751	262 Count	144 Count	14 Count
1777849951	249 Count	136 Count	13 Count
1777848150	231 Count	126 Count	12 Count
1777846349	216 Count	116 Count	11 Count
1777844549	201 Count	108 Count	10 Count
1777842748	184 Count	98 Count	9 Count
1777840948	168 Count	89 Count	8 Count
1777839147	145 Count	81 Count	7 Count
1777837346	129 Count	70 Count	6 Count
1777835551	111 Count	60 Count	5 Count
1777833750	92 Count	49 Count	4 Count
1777831949	71 Count	36 Count	3 Count
1777830149	52 Count	25 Count	2 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)