EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

F6DAY-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F6DAY-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1773704115	46 Count	363 Count	25 Count
1773703152	44 Count	345 Count	24 Count
1773702188	42 Count	324 Count	23 Count
1773701224	40 Count	305 Count	22 Count
1773700260	38 Count	294 Count	21 Count
1773699296	36 Count	281 Count	20 Count
1773698332	34 Count	264 Count	19 Count
1773697368	32 Count	248 Count	18 Count
1773696404	30 Count	229 Count	17 Count
1773695440	27 Count	213 Count	15 Count
1773694477	24 Count	192 Count	13 Count
1773694083	23 Count	185 Count	13 Count
1773693119	21 Count	165 Count	12 Count
1773692155	18 Count	150 Count	10 Count
1773691191	16 Count	135 Count	9 Count
1773690227	13 Count	120 Count	7 Count
1773689263	11 Count	104 Count	6 Count
1773688299	9 Count	88 Count	5 Count
1773687335	7 Count	66 Count	4 Count
1773686371	5 Count	47 Count	3 Count
1773685407	3 Count	28 Count	2 Count
1773684443	1 Count	15 Count	1 Count
1773683479	152 Count	1013 Count	87 Count
1773682515	150 Count	999 Count	86 Count
1773681551	148 Count	984 Count	85 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)