EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

F6DAY-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F6DAY-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1793049711	34 Count	24 Count	23 Count
1793048747	31 Count	22 Count	21 Count
1793047783	27 Count	19 Count	18 Count
1793046819	24 Count	17 Count	16 Count
1793045855	21 Count	15 Count	14 Count
1793044891	18 Count	12 Count	12 Count
1793043927	15 Count	10 Count	10 Count
1793042963	13 Count	9 Count	9 Count
1793041999	9 Count	6 Count	6 Count
1793041034	6 Count	4 Count	4 Count
1793040070	2 Count	1 Count	1 Count
1793039106	0 Count	0 Count	0 Count
1793038142	1002 Count	886 Count	728 Count
1793037178	998 Count	883 Count	725 Count
1793036787	997 Count	883 Count	725 Count
1793035823	995 Count	882 Count	724 Count
1793034859	992 Count	880 Count	722 Count
1793033894	989 Count	878 Count	720 Count
1793032930	988 Count	877 Count	720 Count
1793031966	987 Count	876 Count	720 Count
1793031002	985 Count	874 Count	719 Count
1793030038	983 Count	872 Count	718 Count
1793029074	980 Count	870 Count	716 Count
1793028110	975 Count	866 Count	712 Count
1793027146	971 Count	863 Count	709 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)