EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP3NGH-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP3NGH-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1773733766	651 Count	384 Count	19 Count
1773731963	643 Count	370 Count	19 Count
1773730162	639 Count	356 Count	19 Count
1773728361	631 Count	340 Count	19 Count
1773726560	621 Count	325 Count	19 Count
1773724759	613 Count	294 Count	19 Count
1773722958	607 Count	275 Count	19 Count
1773721157	603 Count	259 Count	19 Count
1773719359	599 Count	245 Count	19 Count
1773717555	595 Count	230 Count	19 Count
1773715754	591 Count	216 Count	19 Count
1773713954	587 Count	202 Count	19 Count
1773712151	583 Count	189 Count	19 Count
1773710350	579 Count	175 Count	19 Count
1773708549	575 Count	162 Count	19 Count
1773706750	571 Count	146 Count	19 Count
1773704947	567 Count	127 Count	19 Count
1773703146	563 Count	111 Count	19 Count
1773701345	558 Count	94 Count	19 Count
1773699543	554 Count	69 Count	19 Count
1773697742	550 Count	66 Count	19 Count
1773695938	546 Count	63 Count	19 Count
1773694138	542 Count	57 Count	19 Count
1773692346	534 Count	57 Count	19 Count
1773690543	529 Count	57 Count	19 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)