EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

HB9EZW-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object HB9EZW-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1773735025	315 Count	566 Count	92 Count
1773734122	314 Count	564 Count	92 Count
1773733290	311 Count	560 Count	90 Count
1773732387	310 Count	559 Count	90 Count
1773731484	309 Count	557 Count	90 Count
1773730581	308 Count	556 Count	90 Count
1773729678	306 Count	554 Count	89 Count
1773728775	304 Count	551 Count	88 Count
1773727872	303 Count	550 Count	88 Count
1773726968	302 Count	550 Count	88 Count
1773726065	301 Count	550 Count	88 Count
1773725162	300 Count	550 Count	88 Count
1773724259	299 Count	549 Count	88 Count
1773723356	298 Count	548 Count	88 Count
1773722453	297 Count	547 Count	88 Count
1773721550	296 Count	545 Count	88 Count
1773720647	295 Count	544 Count	88 Count
1773719744	294 Count	542 Count	88 Count
1773718841	293 Count	541 Count	88 Count
1773717938	292 Count	540 Count	88 Count
1773717035	291 Count	537 Count	88 Count
1773716132	290 Count	536 Count	88 Count
1773715229	289 Count	534 Count	88 Count
1773714326	288 Count	532 Count	88 Count
1773713423	287 Count	531 Count	88 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)