EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP3PSM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP3PSM-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1769633863	343 Count	792 Count	327 Count
1769632062	327 Count	757 Count	312 Count
1769630261	313 Count	709 Count	299 Count
1769628461	277 Count	632 Count	264 Count
1769626660	241 Count	555 Count	229 Count
1769624869	213 Count	485 Count	206 Count
1769623066	190 Count	439 Count	184 Count
1769621266	150 Count	370 Count	145 Count
1769619465	132 Count	326 Count	128 Count
1769617664	111 Count	268 Count	108 Count
1769615863	84 Count	202 Count	82 Count
1769614064	50 Count	133 Count	49 Count
1769612262	21 Count	62 Count	21 Count
1769610461	367 Count	1059 Count	344 Count
1769608660	345 Count	999 Count	323 Count
1769606860	323 Count	938 Count	302 Count
1769605059	301 Count	865 Count	281 Count
1769603266	278 Count	809 Count	263 Count
1769601465	260 Count	753 Count	246 Count
1769599665	241 Count	697 Count	228 Count
1769597864	220 Count	639 Count	208 Count
1769596063	199 Count	574 Count	188 Count
1769594262	184 Count	515 Count	174 Count
1769592462	163 Count	449 Count	154 Count
1769590661	141 Count	377 Count	133 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)