EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP8G-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8G-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1769637869	328 Count	381 Count	271 Count
1769637266	321 Count	372 Count	266 Count
1769636870	311 Count	363 Count	262 Count
1769636571	307 Count	359 Count	259 Count
1769636268	303 Count	353 Count	256 Count
1769635967	299 Count	349 Count	253 Count
1769635667	296 Count	346 Count	251 Count
1769635367	291 Count	338 Count	247 Count
1769634765	284 Count	331 Count	242 Count
1769634164	264 Count	305 Count	224 Count
1769633862	254 Count	290 Count	215 Count
1769633261	232 Count	262 Count	195 Count
1769632660	205 Count	227 Count	170 Count
1769632360	197 Count	219 Count	163 Count
1769631457	171 Count	190 Count	140 Count
1769631156	168 Count	187 Count	138 Count
1769630855	164 Count	182 Count	135 Count
1769629954	154 Count	171 Count	128 Count
1769629652	149 Count	166 Count	124 Count
1769629051	142 Count	159 Count	119 Count
1769628751	138 Count	154 Count	116 Count
1769628149	131 Count	146 Count	111 Count
1769627848	127 Count	142 Count	108 Count
1769627246	120 Count	134 Count	103 Count
1769626946	116 Count	130 Count	100 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)