EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP8PB-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8PB-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1794574542	255 Count	498 Count	189 Count
1794573641	251 Count	489 Count	186 Count
1794572740	246 Count	480 Count	182 Count
1794571839	242 Count	469 Count	179 Count
1794570938	240 Count	462 Count	178 Count
1794570038	238 Count	456 Count	177 Count
1794568990	233 Count	456 Count	177 Count
1794568090	228 Count	446 Count	173 Count
1794567189	222 Count	428 Count	168 Count
1794566288	217 Count	418 Count	164 Count
1794565387	212 Count	408 Count	160 Count
1794564487	207 Count	395 Count	156 Count
1794563586	202 Count	386 Count	152 Count
1794562685	195 Count	371 Count	146 Count
1794561784	192 Count	365 Count	144 Count
1794560883	187 Count	355 Count	140 Count
1794559983	182 Count	346 Count	136 Count
1794559082	177 Count	336 Count	132 Count
1794558181	174 Count	329 Count	130 Count
1794557280	169 Count	319 Count	126 Count
1794556379	165 Count	310 Count	123 Count
1794555479	160 Count	301 Count	119 Count
1794554578	155 Count	292 Count	115 Count
1794553677	150 Count	283 Count	111 Count
1794552776	148 Count	278 Count	110 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)