EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ8PDY-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ8PDY-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1769637911	364 Count	644 Count	344 Count
1769636110	346 Count	616 Count	327 Count
1769634310	322 Count	578 Count	304 Count
1769632509	306 Count	550 Count	289 Count
1769630709	287 Count	512 Count	271 Count
1769628908	263 Count	474 Count	248 Count
1769627108	236 Count	420 Count	222 Count
1769625313	209 Count	383 Count	200 Count
1769623512	192 Count	354 Count	184 Count
1769621711	169 Count	315 Count	162 Count
1769619911	152 Count	287 Count	146 Count
1769618110	128 Count	254 Count	123 Count
1769616310	110 Count	220 Count	106 Count
1769614509	92 Count	192 Count	89 Count
1769612708	69 Count	161 Count	67 Count
1769610908	61 Count	141 Count	60 Count
1769609107	27 Count	76 Count	27 Count
1769607306	559 Count	1033 Count	528 Count
1769605506	527 Count	951 Count	497 Count
1769603711	498 Count	914 Count	473 Count
1769601911	476 Count	853 Count	452 Count
1769598310	416 Count	733 Count	394 Count
1769596509	390 Count	686 Count	369 Count
1769594708	373 Count	653 Count	353 Count
1769592908	349 Count	623 Count	330 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)