EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SM0PQB-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SM0PQB-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1769236784	73 Count	623 Count
1769234981	72 Count	612 Count
1769233178	71 Count	600 Count
1769231375	70 Count	589 Count
1769229605	65 Count	577 Count
1769227802	64 Count	566 Count
1769225999	63 Count	554 Count
1769224196	62 Count	543 Count
1769222393	61 Count	531 Count
1769220590	60 Count	520 Count
1769218787	59 Count	507 Count
1769216984	58 Count	497 Count
1769215181	57 Count	486 Count
1769213378	56 Count	474 Count
1769211575	55 Count	464 Count
1769209772	54 Count	450 Count
1769208003	49 Count	439 Count
1769206200	48 Count	427 Count
1769204397	47 Count	416 Count
1769202593	46 Count	404 Count
1769200790	45 Count	393 Count
1769198987	44 Count	381 Count
1769197184	43 Count	369 Count
1769195381	42 Count	358 Count
1769193578	41 Count	346 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)