EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

PA1MT-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PA1MT-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1791100566	710 Count	535 Count
1791098762	709 Count	534 Count
1791096959	708 Count	533 Count
1791095156	707 Count	532 Count
1791093352	706 Count	531 Count
1791091549	705 Count	530 Count
1791089746	704 Count	529 Count
1791087942	703 Count	528 Count
1791086139	702 Count	527 Count
1791084335	701 Count	526 Count
1791082532	700 Count	525 Count
1791080767	695 Count	524 Count
1791078963	694 Count	523 Count
1791077160	693 Count	522 Count
1791075356	692 Count	521 Count
1791073553	691 Count	520 Count
1791071750	690 Count	519 Count
1791069946	689 Count	518 Count
1791068143	688 Count	517 Count
1791066340	687 Count	516 Count
1791064536	686 Count	515 Count
1791062733	685 Count	514 Count
1791060929	684 Count	513 Count
1791059164	679 Count	512 Count
1791057360	678 Count	511 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)