EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP3PSM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP3PSM-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1781177617	10 Count	147 Count	10 Count
1781175816	75 Count	1077 Count	65 Count
1781174016	64 Count	882 Count	55 Count
1781172215	57 Count	788 Count	49 Count
1781170414	51 Count	631 Count	44 Count
1781168622	32 Count	449 Count	30 Count
1781166821	22 Count	294 Count	21 Count
1781165020	9 Count	125 Count	9 Count
1781163219	50 Count	1103 Count	46 Count
1781161422	42 Count	941 Count	39 Count
1781159618	35 Count	633 Count	33 Count
1781157817	29 Count	469 Count	28 Count
1781156016	10 Count	211 Count	10 Count
1781154215	219 Count	1158 Count	191 Count
1781152414	204 Count	903 Count	177 Count
1781150614	191 Count	836 Count	165 Count
1781148813	185 Count	804 Count	160 Count
1781147021	174 Count	779 Count	154 Count
1781145220	165 Count	755 Count	146 Count
1781143419	158 Count	735 Count	140 Count
1781141618	149 Count	708 Count	132 Count
1781139817	140 Count	675 Count	124 Count
1781138017	130 Count	639 Count	115 Count
1781136216	118 Count	598 Count	104 Count
1781134415	108 Count	559 Count	95 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)