EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ9MJ-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9MJ-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1769026262	102 Count	867 Count	55 Count
1769025361	97 Count	812 Count	54 Count
1769024460	93 Count	742 Count	53 Count
1769022681	82 Count	613 Count	51 Count
1769021780	79 Count	564 Count	50 Count
1769020879	72 Count	489 Count	47 Count
1769019978	43 Count	391 Count	23 Count
1769017275	32 Count	250 Count	18 Count
1769015473	19 Count	158 Count	11 Count
1769014571	16 Count	123 Count	10 Count
1769012769	9 Count	39 Count	7 Count
1769011868	111 Count	1030 Count	38 Count
1769010967	92 Count	980 Count	22 Count
1769010066	86 Count	913 Count	18 Count
1769007363	79 Count	808 Count	18 Count
1769006462	77 Count	775 Count	18 Count
1769005561	75 Count	742 Count	18 Count
1769004660	72 Count	713 Count	18 Count
1769002858	58 Count	606 Count	7 Count
1769001079	48 Count	517 Count	5 Count
1769000178	46 Count	496 Count	5 Count
1768999277	38 Count	457 Count	1 Count
1768998376	35 Count	423 Count	0 Count
1768995673	28 Count	343 Count	0 Count
1768994772	25 Count	321 Count	0 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)