EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP2DRP-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2DRP-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1790590149	409 Count	1047 Count	364 Count
1790588349	373 Count	983 Count	333 Count
1790586547	358 Count	946 Count	322 Count
1790584737	321 Count	883 Count	289 Count
1790582936	282 Count	814 Count	254 Count
1790581135	263 Count	771 Count	240 Count
1790581068	261 Count	767 Count	239 Count
1790581025	259 Count	763 Count	238 Count
1790580957	255 Count	758 Count	236 Count
1790579898	246 Count	732 Count	228 Count
1790579762	244 Count	728 Count	227 Count
1790577961	220 Count	664 Count	204 Count
1790576160	200 Count	613 Count	185 Count
1790574360	181 Count	565 Count	167 Count
1790572559	164 Count	523 Count	151 Count
1790570759	150 Count	487 Count	138 Count
1790568958	138 Count	452 Count	127 Count
1790567157	105 Count	356 Count	95 Count
1790565357	81 Count	223 Count	72 Count
1790563556	67 Count	182 Count	59 Count
1790559961	39 Count	109 Count	37 Count
1790558161	26 Count	75 Count	25 Count
1790556360	12 Count	33 Count	12 Count
1790554559	341 Count	1021 Count	321 Count
1790552759	329 Count	979 Count	310 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)