EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SM0PQB-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SM0PQB-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1773812055	54 Count	506 Count
1773810252	53 Count	493 Count
1773808449	52 Count	482 Count
1773803039	49 Count	447 Count
1773801237	48 Count	437 Count
1773799433	47 Count	423 Count
1773797631	46 Count	413 Count
1773795827	45 Count	401 Count
1773794058	40 Count	391 Count
1773792256	39 Count	379 Count
1773790452	38 Count	368 Count
1773788649	37 Count	356 Count
1773786846	36 Count	345 Count
1773781437	33 Count	311 Count
1773779634	32 Count	301 Count
1773777831	31 Count	289 Count
1773776028	30 Count	279 Count
1773774224	29 Count	266 Count
1773772456	24 Count	257 Count
1773770653	23 Count	243 Count
1773768850	22 Count	232 Count
1773767046	21 Count	217 Count
1773761637	18 Count	183 Count
1773759834	17 Count	170 Count
1773758031	16 Count	159 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)