EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SM0PQB-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SM0PQB-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1773356593	53 Count	506 Count
1773354789	52 Count	493 Count
1773352986	51 Count	482 Count
1773351183	50 Count	469 Count
1773349380	49 Count	457 Count
1773347577	48 Count	445 Count
1773345774	47 Count	433 Count
1773343971	46 Count	421 Count
1773340398	40 Count	397 Count
1773338595	39 Count	386 Count
1773336793	38 Count	373 Count
1773334989	37 Count	362 Count
1773333186	36 Count	348 Count
1773331383	35 Count	338 Count
1773329581	34 Count	324 Count
1773327777	33 Count	312 Count
1773325974	32 Count	300 Count
1773324171	31 Count	288 Count
1773322368	30 Count	273 Count
1773318795	24 Count	250 Count
1773316993	23 Count	239 Count
1773315189	22 Count	226 Count
1773313386	21 Count	215 Count
1773311583	20 Count	201 Count
1773309780	19 Count	191 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)