EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SM0PQB-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SM0PQB-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1777419416	107 Count	900 Count
1777417613	106 Count	889 Count
1777415809	105 Count	878 Count
1777414006	104 Count	865 Count
1777412239	99 Count	854 Count
1777410436	98 Count	841 Count
1777408633	97 Count	830 Count
1777406830	96 Count	814 Count
1777405026	95 Count	804 Count
1777403224	94 Count	790 Count
1777401420	93 Count	779 Count
1777399617	92 Count	767 Count
1777397814	91 Count	755 Count
1777396011	90 Count	742 Count
1777394206	89 Count	731 Count
1777392403	88 Count	718 Count
1777390634	83 Count	708 Count
1777388831	82 Count	698 Count
1777387028	81 Count	687 Count
1777376210	75 Count	627 Count
1777374407	74 Count	614 Count
1777372603	73 Count	603 Count
1777369031	67 Count	580 Count
1777367228	66 Count	567 Count
1777365425	65 Count	556 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)