EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP2AJ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2AJ-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1772570185	103 Count	164 Count	95 Count
1772569284	96 Count	151 Count	89 Count
1772568384	88 Count	136 Count	82 Count
1772567483	81 Count	124 Count	76 Count
1772566582	73 Count	108 Count	69 Count
1772565681	67 Count	95 Count	64 Count
1772564780	42 Count	62 Count	40 Count
1772563880	21 Count	38 Count	20 Count
1772562979	11 Count	19 Count	11 Count
1772562078	305 Count	1012 Count	270 Count
1772561177	296 Count	996 Count	262 Count
1772560277	289 Count	982 Count	256 Count
1772559376	281 Count	968 Count	249 Count
1772558475	269 Count	943 Count	238 Count
1772557574	260 Count	928 Count	230 Count
1772556674	252 Count	913 Count	223 Count
1772555773	235 Count	890 Count	207 Count
1772554872	226 Count	876 Count	199 Count
1772553971	217 Count	860 Count	191 Count
1772553070	209 Count	846 Count	184 Count
1772552170	202 Count	837 Count	178 Count
1772551269	176 Count	797 Count	153 Count
1772550600	175 Count	797 Count	153 Count
1772549700	162 Count	740 Count	141 Count
1772549681	162 Count	740 Count	141 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)