EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

CR7BQX-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object CR7BQX-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1768183284	16 Count	285 Count
1768181483	15 Count	256 Count
1768179681	14 Count	236 Count
1768177880	13 Count	234 Count
1768176097	12 Count	228 Count
1768174295	11 Count	211 Count
1768172494	10 Count	185 Count
1768170692	9 Count	159 Count
1768168891	8 Count	147 Count
1768167089	7 Count	141 Count
1768165288	6 Count	129 Count
1768163487	5 Count	111 Count
1768161685	4 Count	95 Count
1768159884	3 Count	59 Count
1768158082	2 Count	39 Count
1768156281	1 Count	25 Count
1768154496	0 Count	17 Count
1768152695	70 Count	1004 Count
1768150893	69 Count	978 Count
1768149092	68 Count	962 Count
1768147290	67 Count	950 Count
1768145489	66 Count	944 Count
1768143688	65 Count	932 Count
1768141886	64 Count	918 Count
1768140085	63 Count	878 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)