EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

F4GCF-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F4GCF-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	RX*	Digi*
1772109316	585 Count	199 Count
1772108716	570 Count	193 Count
1772108115	556 Count	188 Count
1772107515	540 Count	184 Count
1772106915	523 Count	179 Count
1772106315	509 Count	173 Count
1772105714	495 Count	170 Count
1772105114	477 Count	166 Count
1772104514	455 Count	161 Count
1772103914	442 Count	159 Count
1772103314	432 Count	154 Count
1772102714	404 Count	139 Count
1772102114	366 Count	125 Count
1772101514	362 Count	123 Count
1772100914	353 Count	117 Count
1772100314	348 Count	114 Count
1772099713	334 Count	110 Count
1772099113	322 Count	103 Count
1772098514	317 Count	99 Count
1772097913	310 Count	94 Count
1772097313	303 Count	89 Count
1772096713	288 Count	84 Count
1772096113	278 Count	78 Count
1772095513	263 Count	72 Count
1772094913	250 Count	69 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)