EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP8PB-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8PB-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1768023474	273 Count	358 Count	129 Count
1768022573	271 Count	356 Count	128 Count
1768021673	269 Count	353 Count	127 Count
1768020772	267 Count	351 Count	126 Count
1768019871	265 Count	348 Count	125 Count
1768018971	263 Count	345 Count	124 Count
1768018070	261 Count	341 Count	123 Count
1768017169	259 Count	337 Count	122 Count
1768016269	257 Count	333 Count	121 Count
1768015368	255 Count	330 Count	120 Count
1768014468	253 Count	327 Count	119 Count
1768013567	251 Count	323 Count	118 Count
1768012666	249 Count	320 Count	117 Count
1768011766	247 Count	316 Count	116 Count
1768010880	241 Count	313 Count	115 Count
1768009979	239 Count	310 Count	114 Count
1768009078	237 Count	306 Count	113 Count
1768008178	235 Count	302 Count	112 Count
1768007277	233 Count	297 Count	111 Count
1768006376	231 Count	293 Count	110 Count
1768005476	229 Count	289 Count	109 Count
1768004576	227 Count	286 Count	108 Count
1768003675	225 Count	282 Count	107 Count
1768002774	223 Count	278 Count	106 Count
1768001873	221 Count	275 Count	105 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)