EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

F4GMT-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F4GMT-12. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1789252373	231 Count	475 Count
1789251471	230 Count	473 Count
1789250571	229 Count	470 Count
1789249671	228 Count	468 Count
1789248771	227 Count	465 Count
1789247869	226 Count	463 Count
1789246968	225 Count	460 Count
1789246068	224 Count	458 Count
1789245166	223 Count	455 Count
1789244266	222 Count	453 Count
1789243365	221 Count	450 Count
1789242465	220 Count	448 Count
1789241563	219 Count	445 Count
1789240663	218 Count	443 Count
1789239762	217 Count	440 Count
1789237940	211 Count	435 Count
1789237039	210 Count	433 Count
1789236138	209 Count	430 Count
1789234337	207 Count	425 Count
1789232535	205 Count	420 Count
1789230733	203 Count	415 Count
1789228933	201 Count	410 Count
1789228032	200 Count	408 Count
1789227131	199 Count	405 Count
1789226231	198 Count	403 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)