EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

F4GMT-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F4GMT-12. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1781235734	2 Count	7 Count
1781234833	1 Count	5 Count
1781233933	0 Count	2 Count
1781233032	479 Count	1003 Count
1781232131	478 Count	1000 Count
1781231230	477 Count	998 Count
1781230330	476 Count	995 Count
1781229429	475 Count	993 Count
1781228528	474 Count	990 Count
1781227627	473 Count	988 Count
1781226727	472 Count	985 Count
1781225810	467 Count	983 Count
1781224909	466 Count	980 Count
1781224008	465 Count	978 Count
1781223107	464 Count	975 Count
1781222207	463 Count	973 Count
1781221306	462 Count	970 Count
1781220405	461 Count	968 Count
1781219504	460 Count	965 Count
1781218604	459 Count	963 Count
1781217703	458 Count	960 Count
1781216802	457 Count	958 Count
1781215901	456 Count	955 Count
1781215001	455 Count	953 Count
1781214100	454 Count	950 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)