EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

LB3AG-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object LB3AG-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1789220103	474 Count	989 Count	311 Count
1789219499	464 Count	962 Count	304 Count
1789218896	453 Count	934 Count	297 Count
1789218293	447 Count	915 Count	294 Count
1789217690	440 Count	893 Count	291 Count
1789217087	434 Count	878 Count	288 Count
1789216484	424 Count	858 Count	283 Count
1789215881	418 Count	839 Count	280 Count
1789215278	401 Count	820 Count	278 Count
1789214675	394 Count	799 Count	274 Count
1789214072	386 Count	783 Count	270 Count
1789213469	381 Count	768 Count	268 Count
1789212866	367 Count	740 Count	258 Count
1789212263	352 Count	705 Count	246 Count
1789211659	350 Count	678 Count	245 Count
1789211056	347 Count	653 Count	243 Count
1789210453	342 Count	633 Count	240 Count
1789209850	339 Count	620 Count	238 Count
1789209247	336 Count	607 Count	236 Count
1789208644	333 Count	603 Count	234 Count
1789208041	330 Count	598 Count	232 Count
1789207438	327 Count	591 Count	230 Count
1789206835	324 Count	587 Count	228 Count
1789206232	321 Count	582 Count	226 Count
1789205629	318 Count	576 Count	224 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)