EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

LB3AG-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object LB3AG-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1791208109	10 Count	18 Count	8 Count
1791207506	8 Count	12 Count	7 Count
1791206903	4 Count	7 Count	4 Count
1791206300	573 Count	1004 Count	414 Count
1791205697	571 Count	998 Count	413 Count
1791205094	567 Count	994 Count	410 Count
1791204491	562 Count	985 Count	406 Count
1791203888	560 Count	983 Count	405 Count
1791203285	558 Count	980 Count	404 Count
1791202792	553 Count	973 Count	400 Count
1791202189	552 Count	968 Count	400 Count
1791201586	547 Count	961 Count	396 Count
1791200983	543 Count	953 Count	393 Count
1791200379	542 Count	950 Count	393 Count
1791199776	537 Count	945 Count	389 Count
1791199173	534 Count	940 Count	387 Count
1791198570	532 Count	934 Count	386 Count
1791197967	528 Count	928 Count	383 Count
1791197364	522 Count	919 Count	378 Count
1791196761	520 Count	914 Count	377 Count
1791196158	516 Count	910 Count	374 Count
1791195555	511 Count	901 Count	370 Count
1791194952	509 Count	894 Count	369 Count
1791194349	505 Count	890 Count	366 Count
1791193746	500 Count	881 Count	362 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)