EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SO3Z-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SO3Z-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1767283480	96 Count	213 Count	84 Count
1767281680	88 Count	195 Count	77 Count
1767279879	79 Count	144 Count	69 Count
1767278079	67 Count	122 Count	58 Count
1767276278	52 Count	97 Count	44 Count
1767274477	34 Count	66 Count	27 Count
1767272683	20 Count	48 Count	18 Count
1767270883	12 Count	31 Count	11 Count
1767269082	3 Count	10 Count	3 Count
1767267281	437 Count	1013 Count	368 Count
1767265481	429 Count	992 Count	361 Count
1767263680	421 Count	947 Count	354 Count
1767261880	412 Count	928 Count	346 Count
1767260079	404 Count	910 Count	339 Count
1767258278	394 Count	891 Count	330 Count
1767256478	384 Count	871 Count	321 Count
1767254677	374 Count	853 Count	312 Count
1767252877	365 Count	834 Count	304 Count
1767251082	352 Count	816 Count	296 Count
1767249282	342 Count	797 Count	287 Count
1767247481	331 Count	776 Count	277 Count
1767245684	323 Count	762 Count	270 Count
1767243880	317 Count	750 Count	265 Count
1767242079	312 Count	741 Count	261 Count
1767240279	307 Count	732 Count	257 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)