EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ9MJ-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9MJ-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1773725975	20 Count	445 Count	9 Count
1773722370	5 Count	218 Count	0 Count
1773721470	4 Count	157 Count	0 Count
1773720568	3 Count	110 Count	0 Count
1773712482	23 Count	737 Count	0 Count
1773711581	21 Count	699 Count	0 Count
1773710680	20 Count	651 Count	0 Count
1773708878	17 Count	559 Count	0 Count
1773707978	15 Count	517 Count	0 Count
1773707077	14 Count	471 Count	0 Count
1773706176	13 Count	430 Count	0 Count
1773705275	12 Count	389 Count	0 Count
1773704374	10 Count	346 Count	0 Count
1773703473	9 Count	299 Count	0 Count
1773702572	8 Count	264 Count	0 Count
1773701671	7 Count	221 Count	0 Count
1773700770	5 Count	181 Count	0 Count
1773699869	4 Count	127 Count	0 Count
1773698968	3 Count	86 Count	0 Count
1773698067	2 Count	41 Count	0 Count
1773697166	52 Count	1024 Count	2 Count
1773696264	51 Count	974 Count	2 Count
1773694463	49 Count	886 Count	2 Count
1773693562	47 Count	861 Count	2 Count
1773692661	46 Count	824 Count	2 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)