EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ9MJ-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9MJ-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1793182198	159 Count	946 Count	89 Count
1793181297	158 Count	929 Count	89 Count
1793180419	156 Count	906 Count	89 Count
1793179518	154 Count	892 Count	88 Count
1793178617	150 Count	878 Count	85 Count
1793177716	148 Count	864 Count	84 Count
1793176815	145 Count	855 Count	83 Count
1793175914	143 Count	824 Count	82 Count
1793175013	141 Count	805 Count	81 Count
1793174112	139 Count	781 Count	80 Count
1793173211	135 Count	755 Count	78 Count
1793172310	133 Count	736 Count	77 Count
1793171409	124 Count	715 Count	69 Count
1793170508	106 Count	686 Count	52 Count
1793169607	101 Count	669 Count	50 Count
1793168706	99 Count	657 Count	49 Count
1793167805	96 Count	643 Count	47 Count
1793166904	94 Count	617 Count	46 Count
1793166003	90 Count	587 Count	44 Count
1793165102	88 Count	569 Count	43 Count
1793164201	86 Count	546 Count	42 Count
1793163300	83 Count	526 Count	40 Count
1793162399	80 Count	509 Count	39 Count
1793161498	77 Count	494 Count	37 Count
1793160597	75 Count	480 Count	36 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)