EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP9ZS-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9ZS-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1767283335	84 Count	821 Count	52 Count
1767282434	78 Count	773 Count	48 Count
1767281534	74 Count	724 Count	46 Count
1767280632	67 Count	666 Count	42 Count
1767279732	62 Count	590 Count	39 Count
1767278831	56 Count	521 Count	35 Count
1767277930	51 Count	466 Count	32 Count
1767277030	47 Count	420 Count	29 Count
1767276129	42 Count	368 Count	26 Count
1767275229	35 Count	309 Count	22 Count
1767274328	30 Count	264 Count	19 Count
1767273427	24 Count	223 Count	15 Count
1767272527	19 Count	185 Count	12 Count
1767271626	14 Count	148 Count	9 Count
1767270725	9 Count	108 Count	6 Count
1767269825	3 Count	50 Count	2 Count
1767268924	102 Count	1017 Count	54 Count
1767268023	98 Count	949 Count	51 Count
1767267123	94 Count	899 Count	48 Count
1767266237	81 Count	831 Count	44 Count
1767265337	68 Count	763 Count	41 Count
1767264436	61 Count	681 Count	37 Count
1767263535	55 Count	623 Count	34 Count
1767262635	49 Count	556 Count	30 Count
1767261734	44 Count	498 Count	27 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)