EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

HB9IMG Telemetry

This is the latest recevied telemetry packets stored in our database for station/object HB9IMG. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1789245794	65 Count	45 Count	35 Count
1789242225	52 Count	38 Count	28 Count
1789240422	47 Count	34 Count	24 Count
1789238619	43 Count	31 Count	21 Count
1789236815	39 Count	22 Count	18 Count
1789231405	25 Count	7 Count	7 Count
1789217016	9 Count	3 Count	3 Count
1789213410	7 Count	3 Count	3 Count
1789207999	2 Count	1 Count	1 Count
1789204393	1000 Count	457 Count	432 Count
1789202589	999 Count	457 Count	432 Count
1789200785	998 Count	457 Count	432 Count
1789199019	993 Count	457 Count	432 Count
1789193609	989 Count	456 Count	431 Count
1789191806	985 Count	453 Count	428 Count
1789188199	979 Count	449 Count	424 Count
1789186396	974 Count	445 Count	420 Count
1789184592	971 Count	443 Count	418 Count
1789182789	968 Count	441 Count	416 Count
1789180986	966 Count	440 Count	415 Count
1789179182	962 Count	437 Count	412 Count
1789175613	951 Count	432 Count	407 Count
1789172006	944 Count	427 Count	402 Count
1789168399	938 Count	423 Count	398 Count
1789166596	935 Count	421 Count	396 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)