EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP2AJ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2AJ-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1789247921	465 Count	768 Count	398 Count
1789247020	460 Count	759 Count	394 Count
1789246120	454 Count	746 Count	389 Count
1789245219	448 Count	734 Count	384 Count
1789244318	440 Count	720 Count	377 Count
1789243417	430 Count	704 Count	368 Count
1789242517	418 Count	687 Count	357 Count
1789241616	394 Count	656 Count	334 Count
1789240715	387 Count	642 Count	328 Count
1789239814	380 Count	620 Count	322 Count
1789238914	374 Count	606 Count	317 Count
1789238013	369 Count	595 Count	313 Count
1789237112	364 Count	587 Count	309 Count
1789236211	360 Count	579 Count	306 Count
1789235311	352 Count	567 Count	299 Count
1789234410	348 Count	558 Count	296 Count
1789233509	343 Count	549 Count	292 Count
1789232630	340 Count	543 Count	290 Count
1789231729	333 Count	534 Count	284 Count
1789230828	325 Count	524 Count	277 Count
1789229927	320 Count	506 Count	273 Count
1789229026	314 Count	498 Count	268 Count
1789228125	289 Count	470 Count	244 Count
1789227223	264 Count	444 Count	220 Count
1789226320	247 Count	424 Count	204 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)